中空玻璃打膠機不出膠的原因及解決方法：
Reasons and solutions for failure to release glue from insulating glass sealant dispenser:
1、檢查氣源是否在0.6～0.8Mpa之間；
1. Check whether the air source is between 0.6 and 0.8Mpa;
2、在觸摸屏的編輯功能菜單中檢查印章是否未使用；
2. Check whether the seal is not used in the edit function menu of the touch screen;

3、檢查氣動開關是否被擋?。?br /> 3. Check whether the pneumatic switch is blocked;
4、檢查黑膠氣動開關和電磁閥動作是否正常；
4. Check whether the black glue pneumatic switch and solenoid valve operate normally;
5、檢查比例泵上的智能壓力表是否報警，范圍7-35Mpa；
5. Check whether the intelligent pressure gauge on the proportional pump alarms, with the range of 7-35Mpa;
6、檢查液壓站內是否有壓力，若無壓力： 1）清洗比例溢流閥 2）檢查比例控制器是否通電或松動；
6. Check whether there is pressure in the hydraulic station. If there is no pressure: 1) clean the proportional overflow valve; 2) check whether the proportional controller is energized or loose;
7、清洗時白膠是否可以釋放，如果不能，檢查313軟管和旋轉接頭是否堵塞；
7. Whether the white glue can be released during cleaning, if not, check whether the 313 hose and rotary joint are blocked;
8、檢查一組比例泵下限傳感器IB233是否有信號，檢查第二組比例泵IB407是否有信號；
8. Check whether there is a signal from the lower limit sensor IB233 of one group of proportional pumps and whether there is a signal from the second group of proportional pumps IB407;
9、手動檢查中空玻璃打膠機的掃描數值是否正常。
9. Manually check whether the scanning value of the insulating glass sealant applicator is normal.
以上就是為大家介紹的有關中空玻璃加工設備詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://m.bjrcc.com.cn
The above is a detailed introduction to the insulating glass processing equipment, and we hope it will be helpful to you. If you have any questions, please contact us. We will provide services for you with our attitude http://m.bjrcc.com.cn