1.由于雙組份密封膠的固化需要一定時間，因此雙組份打膠機，已涂了雙組份密封膠的玻璃應水平輕輕搬動。
　1., since the curing of two component sealants takes a certain time, the two component glue machine has been coated with two components of sealant glass and should be moved gently.
　2.A組、B組份膠應保持清潔，嚴防異物進入膠中。
　Group 2.A and B components should be kept clean, and foreign matters should be strictly prevented from entering the glue.
　3.在連續工作過程中，膠槍每次停止工作時間一般不得超過20分鐘，否則，應用A組份膠沖出全部混合膠，直至單一的A組份膠從槍口排出為止。
　3. in the continuous working process, the glue gun will not stop working more than 20 minutes each time. Otherwise, all the mixed glue is washed out with A component glue until the single A component is discharged from the muzzle.
　4.高壓膠管不得強行擠壓、彎曲，防止影響系統正常工作。
　4., high pressure hose should not be forced to bend or bend to prevent the system from functioning normally.
　5.混膠器應經常保持暢通，以保證良好的出膠效果。如遇堵塞情況，可用丙酮浸泡后清洗。建議每5組清洗一次。
　5., rubber mixer should be kept regular and smooth, so as to ensure good glue production. In case of clogging, acetone can be soaked and cleaned. It is suggested that every 5 groups be cleaned once.
　6.當膠槍長時間不用時（超過一周），應拆下槍體使用溶劑將膠槍和混膠器內的殘留膠體清洗干凈。
　6.,when the glue gun is not used for a long time （more than a week）， the gun body should be removed and the residual colloid in the glue gun and glue mixing machine should be cleaned with solvents.
　7.不同雙組份膠生產廠家所生產的膠內含雜質數量不同，根據實際情況清晰B組分的過濾網及單向止回閥，建議每兩組清洗一次。
　7. the number of impurities in the rubber produced by the different double component rubber manufacturers is different. According to the actual situation, the filter net and the one-way check valve of the B component are clear. It is suggested that every two groups be cleaned once.
　本文由雙組份打膠機為您提供，我們的網站是：http://linshi.jncsjx.com我們將以全心全意的熱情為您提供更優質的服務，歡迎您的訪問！
　This article is provided by the double component glue machine for you. Our website is: http://m.bjrcc.com.cn we will provide you with more quality service and welcome your visit with wholehearted enthusiasm.