中空玻璃由兩層或多層平板玻璃組成。中空玻璃機用高強度、高氣密性復合粘結劑將兩個或多個玻璃與密封條和玻璃條粘接密封。中間充入干燥氣體，框架內充入干燥劑，保證玻璃片之間空氣的干燥度。可根據需要選擇不同性能的玻璃原片，如無色透明浮法玻璃壓花玻璃、吸熱玻璃、熱反射玻璃、夾絲玻璃、鋼化玻璃等。并與框架(鋁框架或玻璃條等)粘結、焊接或熔接而成。目前國內市場上中空玻璃只有兩種，槽鋁中空玻璃和膠條中空玻璃。由此一般用中空玻璃設備，來操作。
Insulating glass consists of two or more layers of flat glass. The insulating glass machine uses high-strength, high air tightness composite adhesive to bond and seal two or more glasses with the sealing strip and the glass strip. Dry gas is filled in the middle and desiccant is filled in the frame to ensure the dryness of the air between the glass sheets. You can select glass sheets with different properties according to your needs, such as colorless transparent float glass, embossed glass, heat absorbing glass, heat reflecting glass, wired glass, tempered glass, etc. It is bonded, welded or welded with the frame (aluminum frame or glass strip, etc.). At present, there are only two kinds of insulating glass in the domestic market, i.e. channel aluminum insulating glass and adhesive strip insulating glass. Therefore, insulating glass equipment is generally used for operation.
用中空玻璃設備用途，玻璃切割是如果下料的
Use of insulating glass equipment. If the glass is cut
原玻璃一般為無色浮法玻璃或其他彩色玻璃，遮陽玻璃、鋼化玻璃、夾層玻璃，厚度一般為3-12MM，上述玻璃符合GB11614中、優等品的要求，經檢驗合格后方可使用。玻璃切割可以手動或機器進行，但應符合尺寸要求。在操作過程中，工人應隨時注意玻璃表面不得劃傷，內質均勻，不得有氣泡、夾渣等明顯缺陷；
The original glass is generally colorless float glass or other colored glass, sun shading glass, tempered glass and laminated glass, with a thickness of 3-12mm. The above glass meets the requirements of gb11614 for medium and high-quality products, and can be used only after passing the inspection. Glass cutting can be carried out manually or by machine, but shall meet the dimensional requirements. During operation, workers should always pay attention that the glass surface should not be scratched, the inner quality should be uniform, and there should be no obvious defects such as bubbles and slag inclusions;
玻璃清洗干燥：
Glass cleaning and drying:
玻璃清洗采用機器清洗，因為人工清洗不能保證清洗質量。清洗前應檢查玻璃無劃痕。為了保證密封膠與玻璃的附著力，使用去離子水。此外，為了保證水的循環利用，節約水資源，可以過濾水，保證長期使用。清洗后的玻璃應通過光照檢查，檢查玻璃表面是否有水滴、水漬等污漬。如果有水滴、水漬等污漬，需要調整機器的運行速度、加熱溫度、風量和刷子間隙，直到效果完好。清洗后的玻璃應在1小時內組裝成中空玻璃。另外，要保證玻璃之間不會有摩擦和劃傷。有半成品玻璃儲存車，將玻璃片與片子隔開；
Machine cleaning is adopted for glass cleaning, because manual cleaning cannot guarantee the cleaning quality. Check whether the glass is free of scratches before cleaning. To ensure the adhesion between sealant and glass, use deionized water. In addition, in order to ensure the recycling of water and save water resources, water can be filtered to ensure long-term use. The cleaned glass shall be inspected by light to check whether there are water drops, water stains and other stains on the glass surface. If there are water drops, water stains and other stains, it is necessary to adjust the running speed, heating temperature, air volume and brush clearance of the machine until the effect is intact. The cleaned glass shall be assembled into hollow glass within 1 hour. In addition, ensure that there is no friction and scratch between the glasses. There are semi-finished glass storage vehicles to separate glass sheets from each other;
以上就是為大家介紹的全自動封膠線http://linshi.jncsjx.com的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務.
The above is the fully automatic sealing line introduced for you http://linshi.jncsjx.com I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service